Double-click crusher sand making machine

Double-click crusher is also called double-rotor hammer crusher. Here is a detailed introduction about it:

Working principle: Driven by dual motors, two sets of rotors connected in series rotate at high speed at the same time. The materials in the machine cavity are crushed by the upper rotor and then crushed again by the hammer of the rapidly rotating lower rotor. The materials in the cavity collide with each other at high speed and crush each other, achieving the effect of hammer powder and material powder, forming particles with a discharge size of less than 3 mm1.
Performance characteristics

No clogging phenomenon: There is no screen bar grate bottom, all kinds of wet slag can be crushed, even materials fished out of the water can be crushed at any time, there is no adhesion and clogging problem, and the size of the material can be controlled by adjusting the gap between the crushing hammer heads1.
Wear-resistant hammer head: High-alloy wear-resistant hammer head is used, and the hammer head and hammer handle are used in combination. Only the hammer head is replaced, not the hammer handle, which reduces the replacement cost of wearing parts1.
Shifting gap adjustment technology: The hammer head does not need to be repaired after wear. It can be used repeatedly by moving the position. One pair of hammer heads can be used as three pairs of hammer heads, which improves the utilization rate of the hammer head and reduces the cost of use1.
Bidirectional rotation: The crusher rotates in both directions. Through continuous equal-shift bidirectional operation, the hammer head and the crushing tooth plate can be evenly worn, reducing the frequency of stopping to replace wearing parts1.
Uniform particle size of the discharge material: large crushing ratio, high output, low energy consumption, more than 20 tons of material can be crushed per hour, and the cost of crushing each ton of coal slag does not exceed 1.8 yuan, and the discharge particle size is uniform, which can meet a variety of production needs1.
Suitable for brittle materials: Suitable for fine crushing of brittle materials, no clogging, less dust, low noise, and improved working environment1.
Improve the life of wearing parts: shorten the time that the material stays in the crushing chamber, reduce the scouring and wear of the material on the wearing parts, and improve the service life of the wearing parts1.
Easy installation and maintenance: Easy installation, greatly improving the freedom of the equipment; the side doors on the upper side of the crusher can be opened, making the maintenance of the crusher and the replacement of wearing parts faster and more convenient, shortening the maintenance time1.
Easy operation: Electric-hydraulic operation, one person can easily complete the operation, maintenance, replacement of parts and other tasks of this machine1.
Application field: Suitable for crushing materials such as calcite, limestone, coal slag, slag, shale, coal gangue, construction waste, and construction waste in brick and tile factories, solving the problem of using gangue and coal slag as additives and internal fuels in brick factories, and using gangue and shale to produce standard bricks, hollow bricks and other high-humidity materials.